Palomar College logo - Learning for Success

Permanent Signage

Vehicle Identification

 A. Markings: each Palomar College-owned vehicle must display clear identification which shows that the vehicle belongs to the college.  This identification can be the District logo, the athletic logo or icon, or a combination of the two.

 B. Safety: "How am I driving?" information should appear on the back of each vehicle.

 C. Emergency: District emergency contact information should appear on the back of each vehicle.

 D. Identification: a vehicle number should also appear on the back of each vehicle.

Buildings and Grounds

 A. Campus "Way-finding System":

The Facilities Master Plan proposes a campus directional way-finding system that includes directional maps, signage and related information to address the pedestrian traffic patterns around the campus.

 

B.        Building Layout and Identification:

The master-planning architect will recommend changes in the existing layout and assignment of campus buildings. This may include the renaming or renumbering of the buildings.

 

C.        Building Signage: 

1.  Standard Door Signs:  The standard door signs are black plastic with engraved white letters and are installed on both sides of the door.  The signs are centered and mounted 72 inches from the bottom of the door.

2.  ADA Door Signs:  These signs are black plastic with raised white letters and Grade II Braille and are installed on the wall adjacent to the latch side of the door.  The installation must conform to the Americans with Disabilities Act (ADA) requirements.

3.  Slotted Door Signs:  Slotted door signs contain spaces or slots for various titles, such as the name of the office occupant, department, or class information.

4.  Building Identification Signage:  Large, removable sign panels indicate the assigned building number or letters.  These signs should be placed on the ends of each building and/or on the corners of the overhang nearest to the sidewalk.  Each building should have at least one large building identification sign visible from the roadway for use by emergency response units.  Color and style shall match the way-finding system.

5.  Roof Identification:  The building identification should be painted on the roof of each building for use by law enforcement and emergency response personnel.

6.  Large Building Complex Identification:  Any large complex of buildings should have "you are here" maps posted at various locations throughout the complex. The type and style of the maps should match the way-finding directional system.

7.  Department Identification:  A standard size and type of sign should be posted on buildings to identify the departments that are housed in that building.  The color and style will match the way-finding system.

 

D.        Parking Lot Signage:

1.  Each parking lot should have signage at the entrances that identifies the type of parking allowed, rules and regulations, the parking lot number, where to obtain parking permits, and emergency information.

2.      There should be section numbers posted in all of the large parking lots to assist people in identifying the location where they parked their vehicle.  The sections should be identified with the "A" section closest to the buildings, then “B” and “C”, etc. as people walk away from the center of the campus. 

 

E.        Electronic Bulletin Boards: 

  1. One electronic bulletin board or “marquee” is location at the campus entrance on Mission Road.  Requests for messages on the marquee are submitted to and approved by the Public Information Office.

  2. There should be a several electronic bulletin boards located at various areas around the campus and coordinated by the Public Information Office.  The bulletin boards should be linked so they can distribute general and emergency information.  

 

Streets and Freeways

 

1.  All freeway signage in this area is installed under the guidelines of the CalTrans Standards Manual.

2.  The Advancement Office works with CalTrans and local city jurisdictions to identify the size and type of street and highway signs allowed.

3.  This office also recommends locations where new signs are needed to assist people in locating the College campus and educational centers. 

4,  Current roadway signage also indicates speed limits, traffic flow, pedestrian crosswalks, stop signs, yield signs. There are currently pole mounted signs and signs painted on the asphalt surfaces.

5.  Ways to change Comet Circle to a two-way street should be explored.

PDF Version of Permanent Signage Section

Return to Graphics Standards Manual Index